![Tower 3d pro commands](https://kumkoniak.com/60.jpg)
![tower 3d pro commands tower 3d pro commands](https://flyawaysimulation.com/media/images14/images/tower-3d-logo.jpg)
![tower 3d pro commands tower 3d pro commands](https://live.staticflickr.com/5095/5430628178_c32353eaf0_b.jpg)
Basically these options take the nozzle to some set positions automatically, so you don’t have to move the bed.
![tower 3d pro commands tower 3d pro commands](https://live.staticflickr.com/3827/13748677535_70d2c6eba9_b.jpg)
Go back to the Tools menu, press on “Level” and select each corner and the center one by one, so you can perform the leveling of the bed.Go back to the Tools menu and go to “Home”, then press “Home” so that the nozzle goes to the corner.Press the “Extrude” button so you can set the bed heat, then press “Add” until you reach 60°.Go to Tools > Heat > Add and press the “Add” button until you reach about 200°.Since you will be using a bed and nozzle which warps at high temperatures you need for printing, you should level the build platform at operating temperatures too. Leveling the Artillery Sidewinder X1īefore getting into the steps for calibrating different printer settings, you want to level the print bed.
![tower 3d pro commands tower 3d pro commands](https://live.staticflickr.com/65535/2919234497_00be89b383_b.jpg)
You also need to type additional commands to save your calibration settings, since EEPROM (the saving new settings feature) is not enabled in the firmware that the printer comes with. This is because you either need to directly modify the G-code using your slicer software, or use a separate host software to communicate with the printer. The differences are very significant.įollow through this article to properly calibrate your Artillery Sidewinder X1 so get some great 3D prints.įor the Sidewinder X1 printer, doing the calibration differs a bit from the (more straightforward) process of other printers, such as Creality Ender machines. The stock firmware doesn’t allow you to adjust the extruder steps so you’ll need to use OctoPrint or Pronterface to input some of these values.Ĭalibrating your 3D printer can bring some great improvements in your 3D models.Ĭheck out the results below of one user who calibrated his Artillery Sidewinder X1. To calibrate the Artillery Sidewinder X1 you need to first level the bed, then measure and adjust the E-steps, the flow rate, the feed rate and the acceleration. 1.6 Calibrating Acceleration to Reduce Imperfections How to Calibrate the Artillery Sidewinder X1
![Tower 3d pro commands](https://kumkoniak.com/60.jpg)